Body Fat Calculator
Enter your sex, height, neck and waist, plus hip for women, and the calculator estimates body fat with the Navy tape method. A BMI-based option is available for adults. When you add your weight it also shows fat mass and lean mass. Both methods are estimates, and the Navy method is typically off by 3-4 percentage points.
Checked on Rules used
Method note: this is a widely used method, not an official rule, and some of its figures come from secondary sources rather than the original paper.
How the body fat calculator works
Result
How it was worked out
Fill in the fields above to see the result and every step here.
These calculators give estimates for general information. They are not medical advice and do not diagnose anything. Talk to a doctor or a registered dietitian before you change your training or eating, especially if you have a health condition. Method note: this is a widely used method, not an official rule, and some of its figures come from secondary sources rather than the original paper. Estimate only. Real results vary from person to person.
-
Checked on
Source: ACE body fat percentage categories (essential, athletes, fitness, average, obese)
Method note: this is a widely used method, not an official rule, and some of its figures come from secondary sources rather than the original paper.
- In force from Checked on Source: Deurenberg P, Weststrate JA, Seidell JC. Body mass index as a measure of body fatness: age- and sex-specific prediction formulas. 1991;65(2):105-114 (PMID 2043597), Gomez-Ambrosi J et al. Clinical usefulness of a new equation for estimating body fat (CUN-BAE). 2012;35(2):383-388
-
In force from
Checked on
Source: Hodgdon and Beckett 1984, Prediction of percent body fat for U.S. Navy men from body circumferences and height (NHRC Report 84-11), Hodgdon and Beckett 1984, Prediction of percent body fat for U.S. Navy women (NHRC Report 84-29), Frontiers in Physiology 2023: peer-reviewed article reproducing the U.S. Navy body fat equations
Method note: this is a widely used method, not an official rule, and some of its figures come from secondary sources rather than the original paper.
Worked example: the Navy tape method
A man 180 centimetres tall with a 38 centimetre neck and a 90 centimetre waist gets 19.9 percent body fat from the Navy method. With a typical error of 3-4 percentage points, a fair reading of that figure is a range around it, not one exact number.
How accurate is the estimate
Both methods are estimates from a tape measure or from BMI, not a measurement of fat. The Navy method has a reported typical error of 3-4 percentage points. The Deurenberg formula was published with a standard error of 4.1 percentage points and was derived on people aged 7 to 83, with a separate formula for children; this page uses the adult formula from age 18.
The page shows the number and its likely range. It does not sort the result into named categories, because we could not open a published table of body fat categories to check one against.
How to take the measurements
Measure the neck just below the larynx, the waist at the navel for men or at the narrowest point for women, and the hip at its widest point. Read the tape to the nearest quarter inch (about half a centimetre) and use the same unit for every measurement.
The Navy formula works in inches. If you measure in centimetres, the calculator divides each length by 2.54 first. Putting centimetres straight into the inch formula would give a wrong result.
Method and sources
The Navy method converts every length to inches and uses logarithms of waist minus neck (waist plus hip minus neck for women) and of height. Raw centimetres must never go into the inch formula, so the calculator converts first and checks that the waist is larger than the neck. Results are accepted only between 2 and 60 percent. Measure as follows: neck below larynx, waist at navel (men) / narrowest (women), hip widest; 0.25 in precision. The BMI option uses BF% = 1.20*BMI + 0.23*age - 10.8*sex - 5.4 for adults aged 18 and over, with sex set to 1 for men and 0 for women. Fat mass is weight times body fat, and lean mass is the rest.
Rules and calculation checked on 11 Oct 2026.
Who should not use this
- The Navy tape method has a typical error of three to four percentage points and is less accurate at very low or high body fat.
- Tape-measure and BMI formulas can differ from a DEXA scan by several percentage points.
- The BMI option is for adults aged 18 and over.
- This page gives a percentage and the fat and lean mass but does not label you with a category, because we have no freely citable category table.
- The Navy equations are marked provisional in our data because the original report could not be opened during the check.
These calculators give estimates for general information. They are not medical advice and do not diagnose anything. Talk to a doctor or a registered dietitian before you change your training or eating, especially if you have a health condition. Method note: this is a widely used method, not an official rule, and some of its figures come from secondary sources rather than the original paper. Estimate only. Real results vary from person to person.
Body fat calculator FAQ
How accurate is the Navy body fat calculator?
It is reported to be typically off by 3-4 percentage points, and it is less accurate at very low or very high body fat. Treat the result as a range. In the example, a reading of 19.9 percent could sit a few points either side of that figure.
What is my body fat percentage?
Choose your sex and units, then enter height, neck and waist, with hip as well for women. The calculator estimates your body fat percentage from those tape measurements. Add your weight to see how much of it is fat mass and how much is lean mass.
Is the Navy body fat calculator accurate?
It is accurate enough for a rough estimate, not for a diagnosis. The equations were built by Navy researchers to predict body fat from tape measurements, and they are reported to be off by 3-4 percentage points. Taking the measurements carefully matters as much as the formula.
See also: check your waist-to-hip ratio
Enter weight and height in kg and cm, or lb and feet. See your BMI, the adult band it falls in and the healthy weight range for your height.
Compare your waist with your heightEnter waist and height in cm or inches to see your waist-to-height ratio, the NICE band it falls in and the waist size that equals half your height.
These results are estimates for general information. They are not medical advice and do not diagnose anything. Talk to a doctor or a registered dietitian before you change how you eat, train or sleep because of a number on this page.